|
我買的行家板已下載CH304驅動
但是仍然無法使用 產生下列錯誤碼
請問如何處理
若無法解決 如何退換貨
謝謝
Arduino:1.6.10 (Windows 7), 板子:"Arduino/Genuino Uno"
草稿碼使用了 928 bytes (2%) 的程式儲存空間。上限為 32,256 bytes。
全域變數使用了 9 bytes (0%) 的動態記憶體,剩餘 2,039 bytes 給區域變數。上限為 2,048 bytes 。
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xf1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xf1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xf1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0xf1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0xf1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0xf1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0xf1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0xf1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0xf1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xf1
上傳到板子時發生問題。可行建議請見http://www.arduino.cc/en/Guide/Troubleshooting#upload。
在C:\Users\user\Documents\Arduino\libraries\sketch_oct20a: C:\Users\user\Documents\Arduino\libraries\sketch_oct20a裡找到無效的程式庫
在C:\Users\user\Documents\Arduino\libraries\sketch_oct20a: C:\Users\user\Documents\Arduino\libraries\sketch_oct20a裡找到無效的程式庫
This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences. |
|